KR939SB3 three parameter combination (oil level temperature vibration combination) probe is a general type combined probe that is used in cooling tower fan safety monitoring system. It can be connected with a variety of general two instruments, or computer data acquisition and control system (DCS, PLC, etc.).
This is applied to the fan gear box combined probe for safe operation of monitoring, in its internal integrated measuring temperature, oil level, vibration signal sensing, conversion and transmission circuit of direct output and the security parameters corresponding to the 4 ~ 20mA standard current signal, can be matched with a variety of general-purpose two meter or computer digital acquisition monitoring system.
The probe temperature measurement with platinum resistance sensor and semiconductor integrated device; level measurement using a capacitive sensing principle; sensor for measuring vibration, mechanical vibration acceleration signal acquisition, band-pass filter, an integral and true effective value through the amplifier (RMS) converter, the vibration waveform in the effective bandwidth of it effective value conversion; finally, the oil temperature, vibration generated by the 4 ~ 20mA output.
Main technical performance and indicators
External and installation structures;
KR939SB3 three parameter combination probe, the probe is an external thread form, is installed in the threaded installation hole of the fan reduction box, and the probe rod is inserted into the reduction box, so as to get the lubricating oil temperature, the lubricating oil level and the box vibration signal in the reduction box, and complete the transformation output. Thread specifications and probe inserts need to be declared at the time of order. See Figure1.
[figure 1] exterior pattern
Temperature measurement characteristics;
Measurement range of lubricating oil temperature：0～100 ℃ ，Compreh
-ensive error of temperature measurement：±1℃
Oil level measurement characteristics:
Measurement range of lube oil level：0～50㎜（10 mm for the gear box under normal oil level oil limit position）, Maximum error of oil level measurement： <= ±1㎜
Ambient temperature from -40 to 65 C（Extreme temperature resistance from -50 to 150 C）
Vibration measurement characteristics：
Range of vibration measurement：0～20 ㎜/s ，The measurement output is proportional to the effective value of the vibration velocity (RMS). Frequency range of vibration measurement: 10～1000HZ, Maximum error of vibration measurement: <=±1㎜/s
Signal output characteristics;
Active current type output：DC/4～20mA ，Requirements for passive resistive load。Maximum load resistance：< 300 Ohm
Supply characteristics of power supply：
working voltage：DC/24V±4V，Maximum protection voltage：DC/30V ，Rated current：DC/80mA, Maximum instantaneous working current：120mA，Internal voltage Ambient temperature range：－20～80℃，Ambient humidity range：0～100％（The port is sealed with 704 silicone rubber seals）
Electrical connections：
Two four bit terminals：+24V power supply、GND、It 、t-COM、Io、o-COM、Iv、v-COM：It temperature current signal output；Io oil level current signal output；Iv vibration current signal output：The typical connection refer to the schematic diagram of the connection principle of the probe
JM-B-3Z-02-02-200智能振動監測保護儀
智能轉速表HZS-04
一體化振動溫度變送器VRT-2T
正反轉監測保護儀VB-Z470B（S2184）
一體化振動變送器VIB-100
CS-1-G-075-03-01轉速探頭
VB-Z9500振動速度傳感器
VB-Z500B 旋轉機械狀態監測保護表
VB-Z8600超速（轉速）校驗儀
VB-Z8901振動校驗儀
HZD-B-S振動變送器
HZD-B-5X一體化振動變送器
VB-Z470正反轉監測儀
VB-Z440轉速監測儀
VB-Z470智能反轉速監測表
XZD-YB 一體化防爆振動變送器
CD-21-T振動速度傳感器
CD系列速度傳感器CD21-C CD21-S
TS-V-211智能振動溫度監測儀
HZS-04T-S掛壁式智能反轉速表
振動烈度監測保護儀（壁掛式）
SWZQ-3A風機監控報警器
JM-B-3Z智能振動監測保護儀
HZD-W/L-F 型振動/烈度監測保護儀
CZJ-B振動監測保護儀
CZJ-B2/B3/B4 智能振動監視儀監控儀
CZJ-B3系列振動監視保護儀
MLI-2001雙通道振動監控儀
HZD-W/L-F智能振動監控儀
CZJ-3N振動監測保護儀
HZD-W/L型四通道振動監控儀
RDXZ-2/2N/2NA軸振動監視儀
UT312 測振儀
CZJ-B系列振動監視保護儀
DYZ-L型振動烈度監控儀
DYZ-Z型振動烈度監控
振動數顯報警器ＫＹＳＸ－２０００
振動組合探頭ＫＹＺＤ－３０００
三參數組合探頭KR－939SB3
SDJ-101位移振動保護變送器
SDJ-301軸向位移變送器
VB-Z230，VB-Z230AN振動變送器
普林斯頓PR-9200機殼振動變送器
JK9301B01一體化振動變送器
SDJ-302軸位置保護變送器
TD-9200A 一體化振動變送器
VRT-2（T）型振動速度（及溫度）變送器
SWZT-1F/A分體式振動溫度變送器
KR-939SB3型一體化
KR-939SB4型一體化四參數組合探頭
ST-3振動速度傳感器
HZD-B-9F 振動變送器
HZD-B-6兩線制一體化振動變送器
HZD-B-Ⅰ型振動變送器
HZD-B-S振動變送器
HZD-Z-7型軸振動變送器（帶觸點輸出）
HZD-B-9型振動變送器
HZD-B-5T 一體化防爆振動變送器
HZD-B-8T/HZD-B-8B/振動變送器
HZD-B-4一體化振動變送器
HZD-B-1 振動變送器
HZD-B-8一體化振動變送器
HZD-B-5一體化振動變送器
HZD-B-9/HZD-B-9F振動變送器
KR－939SB3特點：
二線制振動速度傳感器SDJ-SG-2
振動速度傳感器HD-ST-2
HD-ST-3振動速度傳感器
YD9200A系列一體化振動變送器
ZHJ-402一體化振動溫度變送器
ZHJ-201振動溫度傳感器
JM-C-7F正反轉速監測儀
JM-B-3Z/N振動監測儀
JM-C-3轉速監測儀
JM-B-3Z振動轉速監測保護儀
JM-B-7 智能振動監測保護儀（雙通道）
振動變送器ST-3
ST-2振動速度傳感器
SG-2振動傳感器
ZD-01振動變送器
ZD-02型烈度振動變送器
ZD-03型一體化防爆振動變送器
ZD-03A一體化振動變送器
ZD-05一體化振動溫度變送器
ZDI-01型軸振動變送器
YC-DO型脹差變送器
YZ-DO型軸向位移變送器
CZY-01型轉速變送器
YTD-1型位移變送器
殼振動速度傳感器
壓電式一體化振動變送器
一體化振動傳感器
ICP壓電加速度傳感器
一體化帶顯示振動變送器
上一篇 : 軸承振動測量儀的校準方法工作原理
下一篇 : 智能轉速監控儀工作原理
